1. Remove the bypass/duplex motor. (Bypass/Duplex Motor (M2))
  2. Remove the transport guides [A] and [B].
  3. Remove the gears [A], [B], and [C].
  4. Remove the bearings [A], [B], and [C].
  5. Remove the 2 screws.
  6. Remove the two screws on the right side of the bypass paper feed unit [A].
  7. Remove the screw and connector.
  8. Release the tab and loosen the harness bracket [A].
  9. Remove the bypass paper feed unit [A].
  10. Remove the bypass paper end sensor cover [A].
  11. Remove the connector of the bypass paper end sensor [A].
  12. Remove the harness guide [A].
  13. Remove the bypass pick-up solenoid [A] together with the bracket.
  14. Remove the 2 screws.

  15. Remove the bypass pick-up solenoid [A].