Each sensor assembly has a list of characteristic values attached to it. Before you replace the TM/ID sensor, you must do the following procedure, or process control/MUSIC will not be done correctly after power is switched on (it will use the values for the old sensor).

  • The characteristic values attached to the service part must be entered before replacement. It is recommended that in case Process control/MUSIC after replacement is not completed successfully, take a note of values of SP3-333, SP3-334, and SP3-335.

  1. Note the characteristic values that are listed on the barcode label.

    • TM/ID Sensor (front): F, TM/ID Sensor (center): C, TM/ID Sensor (rear): R, be careful.

  2. Turn on the main power switch, and then go into the SP mode.
  3. Input the characteristic values.
    Input data for TM/ID Sensor (S48): F into SP3-333. Input data for TM/ID sensor: C into SP3-334. Input data for TM/ID sensor: R into SP3-335.

SP No.

Classification 1

Classification 2

Value

3-333-001

ID.Sens TestVal:F

K2: Check

TM/ID sensor: F, value of [1]

3-333-002

ID.Sens TestVal:F

Diffuse Corr

TM/ID sensor: F, value of [2]

3-333-003

ID.Sens TestVal:F

Vct_reg Check:Slope

TM/ID sensor: F, value of [3]

3-333-004

ID.Sens TestVal:F

Vct_reg Check:Xint

TM/ID sensor: F, value of [4]

3-333-005

ID.Sens TestVal:F

Vct_dif Check:Slope

TM/ID sensor: F, value of [5]

3-333-006

ID.Sens TestVal:F

Vct_dif Check:Xint

TM/ID sensor: F, value of [6]

3-334-001

ID.Sens TestVal:C

K2: Check

TM/ID sensor: C, value of [1]

3-334-002

ID.Sens TestVal:C

Diffuse Corr

TM/ID sensor: C, value of [2]

3-334-003

ID.Sens TestVal:C

Vct_reg Check:Slope

TM/ID sensor: C, value of [3]

3-334-004

ID.Sens TestVal:C

Vct_reg Check:Xint

TM/ID sensor: C, value of [4]

3-334-005

ID.Sens TestVal:C

Vct_dif Check:Slope

TM/ID sensor: C, value of [5]

3-334-006

ID.Sens TestVal:C

Vct_dif Check:Xint

TM/ID sensor: C, value of [6]

3-335-001

ID.Sens TestVal:R

K2: Check

TM/ID sensor: R, value of [1]

3-335-002

ID.Sens TestVal:R

Diffuse Corr

TM/ID sensor: R, value of [2]

3-335-003

ID.Sens TestVal:R

Vct_reg Check:Slope

TM/ID sensor: R, value of [3]

3-335-004

ID.Sens TestVal:R

Vct_reg Check:Xint

TM/ID sensor: R, value of [4]

3-335-005

ID.Sens TestVal:R

Vct_dif Check:Slope

TM/ID sensor: R, value of [5]

3-335-006

ID.Sens TestVal:R

Vct_dif Check:Xint

TM/ID sensor: R, value of [6]