Target Part/SP No.:Registration Sensor (S16) / SP5-803-001 (Registration Sensor)
| Cause verification | Problem Judgement |
|---|---|
Execute an INPUT check when there is no paper at the position of the referenced sensor. | 0 :Paper detected |
Execute an INPUT check when there is paper at the position of the referenced sensor. | 1: Paper not detected |
Solution:
• Clean the sensor.
• Reconnect the connector.
• Replace the sensor.
• Replace the Paper Transport IOB (PCB1).
• Replace the harness.
Checking Paper Jam, or Paper Status
| Check if there is no double feeding. | Fan the paper. |
| Check if the paper is curled too much. | If the paper is curled too much, switch on the anti-condensation heater for the paper tray. |
Check if extra thin paper or thick paper exceeding the supported paper thickness is being used. | Use a supported paper type. |
| Check if the paper thickness and size are detected correctly | Set the paper thickness and size to the correct value. |