Before opening the corrugated envelope, make sure that the seal has not been broken or peeled off. If the seal has been broken or peeled off (even partially), this is considered an arrival defect. Note that once the seal is peeled off, this will leave a mark on the bag.
- You must check the box seals to make sure that they were not removed after the items were sealed in the box at the factory before you do the installation.
- Check the box seals [A] on each corner of the box.
- Make sure that a tape is attached to each corner.
- The surfaces of the tapes must be blank. If you see "VOID" on the tapes, do not install the components in the box.
- If the surfaces of the tapes do not show "VOID", remove them from the corners of the box.
- You can see the "VOID" marks [B] when you remove each seal. In this condition, they cannot be attached to the box again.
