1. Remove the machine from the box, and check the items in the package.
    Remove the styrofoam [A] at the lower front right before lifting up the machine, because the handle for lifting the machine is hidden by the retainer [A].

    • When you lift the machine, hold the correct parts, as shown in the photo below.
    • Do not lift by holding the scanner unit, etc., because this might deform the machine or break the exterior covers.

  2. Remove the packing tape and retainers on the outside.
    The following photo is an example of an SPDF model.


    • For a model on which SPDF or ARDF is preinstalled, remove the packing tape and retainers on the SPDF or ARDF.
    • For a model on which SPDF, remove the protective sheet as an additional procedure. If the protective sheet remains in the SPDF, a paper jam will be detected.
      1. Open the SPDF.
      2. Release the lever [A], open the pressure plate sheet [B], and pull out the protective sheet slowly.
      3. Remove the packing tape [C].
      4. Close the pressure plate sheet.
      5. Close the SPDF.
     
  3.  Remove the paper size decal [A] on the exposure glass.
  4. Remove the packing tape on the scanner shipping locks.

  5. Remove the two scanner shipping locks [A] by rotating them 90 degrees counterclockwise.
    SC120 is displayed when the machine is turned ON with the shipping lock attached.

    • Keep the scanner shipping locks after installing the machine. The scanner shipping locks must be installed before moving the machine using methods in which the machine will not always be level, such as by truck over rough ground, or by ship.
    • Before moving the machine, make sure to move the scanner carriage to the correct position with SP4-806-001 and reattach the shipping locks. (Main Machine Installation: When Moving the Machine).

  6. Attach the two caps [A] provided with the machine.
  7. Pull out the 1st/2nd paper trays, remove the packing tape.
  8. Remove the scanner support [A].

  9. Open the front cover, and store the scanner support in the storage location.

    • The factory setting sheet is kept in the position [A].
    • The factory setting sheet is stored in the storage part of the scanner support.

SP descriptions

  • SP4-806-001 (Scanner carriage storage operation).
    Moves the scanner carriage to the shipping lock position. Attach the scanner shipping locks and fix the scanner carriage after executing SP4-806-001.