The procedure differs between models as follows.
| Models | CMY | Bk |
|---|---|---|
| IM C6000/C5500/C4500 | Wound automatically when turning on the power | |
| IM C3500/C3000 | Pulled out by hand | Wound automatically when turning on the power |
| IM C2500/C2000 | Pulled out by hand | |
- An automatic initial adjustment will be done even if the seal was not removed correctly. But toner from a PCDU that still has the seal will not be able to reach the ITB, and will not be transferred to printouts and copies.
- If this happens, remove the PCDU seal and do SP2-111-004 (Forced Line Position Adj. Mode d).
- White stripes may appear in the printed images for the first 20k pages printing continuously in a low humid environment, due to the deviation of toner density adjustment. Except for that, the machine operates normally.
- Open the front cover.
- Pull out the seals [A].
For IM C6000/C5500/C4500, the PCDU seals are automatically wound when the power is turned on. Do not turn the power on until the procedure requires that you do so.
- Remove the packing tapes, and remove the spacer [A].
- Rotate the ITB contact/separation lever clockwise, and set it to the position in the following picture.
The separated image transfer belt and OPC drum come into contact.
- Close the front cover.
SP descriptions
- SP2-111-004 (Forced Line Position Adj. Mode d)
Executes the fine line position adjustment and rough line position adjustment.