- Enter the SP mode.
- Output the SMC logging data with SP5-990-004.
Make sure to shut down and reboot the machine once before printing the SMC. Otherwise, the latest settings may not be collected when the SMC is printed. Set the following SPs (New Unit Detection) to "1".
Item
SP
Replacement procedure Development unit
Black: SP3-701-003
Yellow: SP3-701-072
Cyan: SP3-701-026
Magenta: SP3-701-049
PCU/Development Unit PCU
Black: SP3-701-002
Yellow: SP3-701-071
Cyan: SP3-701-025
Magenta: SP3-701-048
PCU/Development Unit Fusing sleeve belt unit
SP3-701-116
Fusing Sleeve Belt Unit Pressure Roller
SP3-701-118 Pressure Roller Image Transfer Belt Unit
SP3-701-093
Image Transfer Belt Unit Image Transfer Belt Cleaning Unit
SP3-701-102
Image Transfer Cleaning Unit Paper Transfer Roller Unit
SP3-701-109
Paper Transfer Roller Waste Toner Bottle
(When the bottle is replaced before the machine detects bottle full and stops)
SP3-701-142 - Exhaust Filter
SP3-701-131
Exhaust Filter ADF Pick-Up Roller: SP3-701-206
Feed Belt:SP3-701-207
Separation Roller: SP3-701-208- - Turn the main power switch OFF, and disconnect the power cord from the outlet.
- Replace the PM parts and turn the main power ON.
The machine will reset the PM counters automatically. In the case of the development unit, developer initialization will also be done automatically. - Exit the SP mode.