1. Connect the power cord and turn the machine on. A message prompts you to format the hard disk.
  2. Touch [Format].

  3. Wait for the machine to finish formatting the hard disk.

    • Do not touch the power switch while the hard disk format is in progress. Wait for the machine to tell you that the formatting is finished.

  4. Turn the main power OFF and back ON again after the message tells you formatting is finished.
  5. Enter the SP mode.
  6. Do SP5-846-040 to copy the address book to the hard disk from the controller board.
  7. Do SP5-846-041 to let the user get access to the address book.
  8. Turn the main power OFF and back ON again.

  9. Ask an administrator to register an HDD authentication code in the machine.

    • If the HDD Authentication Code is not registered, the function of the enhanced security HDD is not activated.

SP descriptions

SP5-846-040

UCS Setting: Addr Book Migration(USB->HDD)

Copies the address book to the hard disk from the controller board.

[Execute]

SP5-846-041

UCS Setting: Fill Addr Acl Info

This SP must be executed immediately after installation of an HDD unit in a basic machine that previously had no HDD. The first time the machine is powered on with the new HDD installed, the system automatically takes the address book from the NVRAM and writes it onto the new HDD. However, the new address book on the HDD can be accessed only by the system administrator at this stage. Executing this SP by the service technician immediately after power on grants full address book access to all users.

[Execute]