Since there are only two SD card slots (one of them is a service slot), three or more SD card applications cannot be used simultaneously.

However, if multiple SD card applications are merged, three or more SD card options can be used.

This function is referred to as the "SD card merge function".

The "SD card merge function" is a function which enables the use of three or more functions within the capacity of two SD cards by physically transferring the function of one SD card to other SD cards (all SD card options can be stored in two SD cards).

However, SD card applications are under license, therefore, since an SD card license after the merge is transferred to the target SD card, it cannot be used even if it is moved to the target machine.

Also, a process to prevent illegal copying is performed.

  • After the merge, store the empty SD card in the location shown below.

  1. Remove the proximity sensor left cover [A].
  2. Open the right door, and then remove the small cover [A].
  3. Open the front cover.

  4. Remove the proximity sensor cover [A].

    • Remember that there is a tab at the positions in the red arrows.
    • Rotate the operation panel [B] upward to a horizontal position, and then detach the proximity sensor cover [A].

  5. Insert the SD card in the storage location inside the cover.

    Up to 3 SD cards can be accommodated.


  6. Put the removed covers back in their original positions.
    When attaching the proximity sensor left cover, be sure to connect the connector.