Target Part/SP No.:Limit Sensor (2nd Feed Tray) (S25) / SP5-803-018 (Tray 2: Upper Limit Sensor)

Cause verification

Problem Judgement

Execute an INPUT check when there is no paper at the position of the referenced sensor.

1: limit

Execute an INPUT check when there is paper at the position of the referenced sensor.

0: Not limit

Solution:

  • Clean the sensor.
  • Reconnect the connector.
  • Replace the sensor.
  • Replace the Paper Transport IOB (PCB1).
  • Replace the harness.
Target Part/SP No.:Paper End Sensor (2nd Feed Tray) (S24) / SP5-803-019 (Tray 2: Paper End Detection)

Cause verification

Problem Judgement

Execute an INPUT check when there is no paper at the position of the referenced sensor.

1: Paper detected

Execute an INPUT check when there is paper at the position of the referenced sensor.

0: Paper not detected

Solution:

  • Clean the sensor.
  • Reconnect the connector.
  • Replace the sensor.
  • Replace the Paper Transport IOB (PCB1).
  • Replace the harness.
Target Part/SP No.:Tray Set Switch (2nd Feed Tray) (S21) / SP 5-803-020 (Tray 2: Set Sensor)

Cause verification

Problem Judgement

Manually press the referenced switch (Done after removing paper feed tray 2 from the machine.)

1: Not set

Pull out the paper feed tray 2 from the machine.

0: Set

Solution:

  • Clean the sensor.
  • Reconnect the connector.
  • Replace the sensor.
  • Replace the Paper Transport IOB (PCB1).
  • Replace the harness.
Target Part/SP No.:Paper Feed Sensor (2nd Feed Tray) (S22) / SP5-803-004 (Paper Feed Sensor 2)

Cause verification

Problem Judgement

Execute an INPUT check when there is no paper at the position of the referenced sensor.

0: Paper detected

Execute an INPUT check when there is paper at the position of the referenced sensor.

1: Paper not detected

Solution:

  • Clean the sensor.
  • Reconnect the connector.
  • Replace the sensor.
  • Replace the Paper Transport IOB (PCB1).
  • Replace the harness.
Target Part/SP No.:Paper Feed Motor (M6) / SP5-804-016 (Feed Motor:CW:Standard Speed)

Cause verification

Problem Judgement

Turn the referenced motor OFF with OUTPUT check

Drive sound heard

Turn the referenced motor ON with OUTPUT check

Drive sound not heard

Solution:

  • Reconnect the connector.
  • Replace the motor.
  • Replace the Paper Transport IOB (PCB1).
  • Replace the harness.
Checking Paper Status, Pick-up Roller, Feed Roller, and Friction Roller for 1st Feed Tray

Check the paper position (Check whether or not the leading edge of the paper, side paper guide, and end paper guide are positioned according to the manual.)

  • Check the paper orientation.
  • Turn the paper in the feed tray upside down.

Check if the paper has reached the maximum stackable limit of the side paper guide.

Reduce the paper to below the stackable limit.

Check if the sheets are stuck to each other due to edge roughness, coating, stain, or temperature.

Fan the paper

Check if extra thin paper or thick paper exceeding the supported paper thickness is being used.

Use supported paper types.

Check if the paper thickness and size are detected correctly.

Set the paper thickness and size to the correct value.

Check if the paper being used produces a lot of paper dust.

Change the paper type (if possible).

Check if the paper roller is not stained with paper dust.

Clean the pick-up roller, feed roller, and friction roller for 1st feed tray.