Lubrication for preventing noise and vibration and for extending life (indicated in red in the following diagram).

  1. Paper exit/pressure release motor gear: gear teeth (1 spot) located in area 0-10 mm from the tip of the shaft
  2. End surface of gear boss (1 spot)
  3. End surface of gear boss (1 spot)
  4. End surfaces of gear teeth (2 spots)
  5. Stud center (1 spot)
  6. Area 45 mm from the tip of the stud (1 spot)

Lubrication parts
  • 4 gears (5 spots)
  • Shaft (stud) (2 spots)
Lubrication amount

Maximum [A] and minimum [B]

Gears

Amount of grease on studs