1. Attach the supplied large clamp to the Double-feed Sensor Board.
  2. Connect the supplied harnesses.
    (From left to right: 7pin, 13pin, 2pin)
  3. Bind the harnesses with the supplied clamp.
  4. Install the Double-feed Sensor Board [A] to the ADF (M3x6).
    Fit the bracket to the positioning projection on the ADF frame and then screw it.
  5. Keep the harness towards the upper side along the cover as shown below.

  6. Connect the 13 pin harness to the ADF main board.
  7. Route and clamp the harness (7pin and 2pin) along the guide.